Dryer Won't Advance Through Cycles? Whirlpool Timer W11105130 — Fix Cycle Control Fast
Dryer stuck mid-cycle, won't advance, or won't shut off on its own? In most Whirlpool and Maytag dryers, this is caused by a failed dryer timer. When the timer fails, the dryer loses the ability to progress through drying phases, coordinate the motor and heating element, or shut off automatically at cycle end. ⚡ Common failure point in Whirlpool-built dryers. Part W11105130 is the genuine OEM replacement that restores full cycle control and automatic operation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dryer powers on and drum turns normally
- ✔ Heating element and motor are confirmed working
- ✔ Power supply and door switch are confirmed OK
- ✔ ONLY problem is the timer not advancing, cycle not completing, or dryer not shutting off
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dryer won't start or turn on
- Timer won't advance through the cycle
- Dryer stops mid-cycle and won't restart
- Timer knob is stuck or won't turn
- Dryer runs continuously and won't shut off
- Specific cycle settings don't work
✔ If these symptoms match, the timer is the most likely failed component.
✔ In most cases, replacing the timer restores normal cycle operation immediately.
📦 Part Details
- Part Number: W11105130
- Type: Dryer Timer — controls cycle progression, motor, heating element coordination, and automatic shutoff
- Replaces: W10648592
- Brands: Whirlpool, Maytag
While the timer is out, inspect the timer knob and shaft for wear or cracking — a damaged knob can cause the same symptoms and should be replaced at the same time. Also check the wiring harness connector at the timer for heat damage or corrosion.
⚙️ Installation
Skill Level: MODERATE — 30 to 45 minutes. Disconnect power before servicing. Access the timer by removing the dryer control panel. Disconnect the wiring harness, remove the mounting screws, and transfer the timer knob to the new unit before installing. Reconnect the harness and reassemble the panel.
✓ Compatible Models
Confirmed compatible with MEDX6STBW0, MEDX6STBW1, MGDX6STBW0, MGDX6STBW1, MGDX6STBW2, YMEDX6STBW0, YMEDX6STBW1 plus additional Whirlpool and Maytag models. Contact us to verify your model number before ordering.
💡 Pro Tip
A dryer that won't heat is usually a heating element or thermal fuse — not the timer. The timer is the right fix when the drum runs but the cycle won't advance, won't complete, or won't shut off automatically. If in doubt, contact us with your model number before ordering.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
