Washer Not Filling? Water Inlet Valve W11165546 – Fix No-Fill & Slow-Fill Fast
If your top-load washer won't fill with water, fills too slowly, or stops mid-cycle, the water inlet valve is the most common cause. In most Whirlpool and Maytag top-load washers, this is caused by a failed water inlet valve. When it fails, the tub won't fill properly, wash cycles stall, and the machine may display fill-related error codes. ⚡ Common failure point in Whirlpool-built top-load washers. Part W11165546 is the genuine OEM replacement that restores full water flow and normal cycle operation immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer powers on and the control panel responds normally
- ✔ The drain and spin functions work correctly
- ✔ Household water supply is confirmed on and water pressure is adequate
- ✔ The lid switch or door latch is functioning (washer attempts to start a cycle)
- ✔ ONLY problem is the tub not filling, filling slowly, or stopping mid-fill
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Washer won't fill with water — most common, tub stays empty after cycle starts
- Washer fills very slowly or takes much longer than normal
- Washer stops mid-cycle during the fill phase
- Only cold or only hot water enters the tub (one solenoid failed)
- F8 E1 or LF error code displayed on the control panel
- Humming noise at start of cycle but no water flow
✔ If these symptoms match, the water inlet valve is the most likely failed component in the system.
✔ In most cases, replacing this water inlet valve restores normal fill operation immediately.
📦 Part Details
- Part Number: W11165546
- Type: Dual-solenoid water inlet valve assembly (hot & cold)
- Replaces: OEM direct-fit water inlet valve assembly — supersedes W10599423, W10758828, W10839828, W11096267 (no modification required)
- Brands: Whirlpool, Maytag, Amana
While the washer is open, inspect the inlet hose screens and water supply hoses for sediment buildup or cracking — clogged screens are a leading cause of premature valve failure. Replacing both at the same time prevents a repeat service call within months.
⚙️ Installation
Skill Level: EASY — 20–30 minutes. Unplug the washer and shut off both water supply valves before beginning. Remove the rear access panel, disconnect the wire harness and inlet hoses from the old valve, swap in the new W11165546, and reconnect in reverse order. No special tools required — a ¼" nut driver handles all fasteners.
💡 Pro Tip
Before ordering, remove the inlet hoses and inspect the small mesh screens inside the valve ports. If they're clogged with sediment, cleaning them may restore flow without a part replacement. If the screens are clear and the valve still won't open, the solenoid coil has failed and W11165546 is your fix.
Model hub pages: MVWB835DW, WTW8500DC, MVWB855DW, WTW8500DW, MVWB765FW, WTW7500GW, MVWB865GW, WTW5100HW, MVW7230HW, 7MMVWB855EC
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
