Microwave Turntable Wobbling or Not Spinning? Turntable Support W11252182 — Fix Uneven Heating Fast
A wobbling, grinding, or non-spinning turntable is almost always caused by a cracked or worn turntable support coupler. In most Whirlpool-built microwaves, the turntable support sits beneath the glass tray and drives rotation from the motor coupling. When it cracks, chips, or wears out, the tray wobbles, grinds, or stops spinning entirely — causing uneven heating and hot spots in every meal. ⚡ One of the most common wear parts in Whirlpool-built microwaves. Part W11252182 is the genuine OEM replacement that restores smooth, even turntable rotation and consistent cooking performance.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Microwave powers on and heats normally
- ✔ Turntable motor runs (you can hear it)
- ✔ Glass tray is intact and not cracked
- ✔ ONLY problem is wobbling, grinding noise, or tray not rotating smoothly
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Turntable wobbles or rocks during operation
- Grinding or scraping noise when microwave runs
- Glass tray stops rotating mid-cycle
- Food heats unevenly with consistent hot and cold spots
- Visible cracks or missing legs on the existing support
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this turntable support restores smooth, quiet rotation immediately.
📦 Part Details
- Part Number: W11252182
- Type: Microwave Turntable Support / Drive Coupler
- Replaces: WPW10654906, W10654906, W11193600, W10435114, 8206227, 8205778, 8184102, 8169331, 4393752
- Brands: Whirlpool, Maytag, KitchenAid, Jenn-Air
While the tray is out, inspect the turntable motor and glass tray for wear or hairline cracks. A worn motor can cause premature failure of a new support coupler — replacing both at the same time ensures a complete, lasting fix.
⚙️ Installation
Skill Level: Easy — 5 minutes, no tools required. Disconnect power before servicing. Remove the glass turntable tray, lift out the old support coupler, drop the new W11252182 into place over the drive shaft, and replace the glass tray. Power on and verify smooth rotation before use.
✓ Compatible Models
Confirmed compatible with WMH31017AS, WMH73521CS, WMC30516AS, MMV4205DS, MMV4205DW, MMV4205DB, and a wide range of Whirlpool, Maytag, KitchenAid, and Jenn-Air microwave models. Contact us to verify your model number before ordering.
💡 Pro Tip
Before installing the new support, inspect the turntable motor drive shaft for wear or stripping. A worn shaft will chew through a new coupler quickly. If the shaft spins freely without resistance or shows visible wear, the turntable motor should be replaced at the same time to protect your new part.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
