GE (General Electric) Dishwasher Drain Hose WG04F01563, Replaces WD24X10014

Genuine OEM GE dishwasher drain hose, approximately 77-1/2 inches long. It carries wastewater from the dishwasher drain pump to the kitchen sink drain or household drain connection.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Slow or incomplete draining caused by a kink, restriction, or blockage in the hose
• Water leaking beneath the dishwasher or inside the sink cabinet from a damaged hose or connection
• Repeated drain-related problems after the dishwasher is pushed back into place and the hose becomes pinched
• Wastewater returning to the dishwasher when the hose is routed without the required high loop or air gap

Check Before Replacing

• Turn off electrical power to the dishwasher before inspecting connections or routing.
• Visually inspect the entire accessible hose run for kinks, crushing, cuts, soft spots, or disconnected ends.
• Check the hose connections at the dishwasher drain pump and sink, waste tee, or disposer for looseness or visible leakage.
• Confirm that the hose is routed with the required high loop or through an air gap, as applicable to the installation.
• If connected to a garbage disposer, verify that the dishwasher inlet knockout plug has been removed.
• Check the sink-side drain fitting or air-gap opening for visible blockage before concluding that the hose is defective.

Pro Tip

Part Details

Key Features

• Genuine OEM GE dishwasher drain hose
• Approximately 77-1/2 inches long
• Designed to carry dishwasher drain water to the household drain connection
• Applicable to GE-family dishwasher installations identified in the trusted archive
• Replacement reference documented as WD24X10014

Installation Notes

• Disconnect electrical power before beginning service.
• Route the hose without kinks, sharp bends, crushing, or abrasion.
• Connect the molded hose end fully to the dishwasher drain-pump outlet and secure it according to the applicable GE installation instructions.
• Connect the opposite end to the air gap, waste tee, or disposer using the installation’s required connection method.
• Maintain the required high-loop or air-gap routing; GE states that built-in dishwasher drain hoses generally require a 32-inch high loop when an air gap is not used.
• If connecting to a disposer, confirm that the disposer dishwasher-port knockout plug has been removed before operating the dishwasher.

Verified Compatible Models

GDF520PGJ2WW, GDF630PGM0BB, GDT635HSM0SS, GDT655SSJ0SS, GDT695SSJ2SS, GSD2100V35WW, GSD3300D35BB, GSD3300D35WW, GSD3360D00SS, GSD3360D35SS, HDA2100V00WW, HDA2100V35WW, MSD2100V35WW, VSD2304P00SB, GLV1426P00WW, GLV7800G01SS, GLV7800GSS02, GSD2100V35BB, GSD2100V45WW, GSD3360D50SS, GSD3360K65SS, GSD4060K00SS, GSD4060K55SS, LVG7800G01SS, ZBD6880K00SS, ZBD6880K03SS

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.