Whirlpool Corporation Washer spin belt / washer drive belt WP27001007, Replaces 27001007, 37820, 40053602, 40053607, 2200062

Genuine Whirlpool washer spin/drive belt, approximately 30 1/4 inches long and 1/2 inch wide, used to transfer motor power to the washer drive system and spin basket.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Washer does not spin
• Washer does not agitate
• Slow or incomplete spinning, leaving clothes wet
• Burning-rubber odor during operation
• Belt-related squealing, slipping, or unusual noise
• Washer may pump but fail to drive the basket

Check Before Replacing

• Disconnect electrical power before inspection or service.
• Inspect the belt for breakage, fraying, glazing, looseness, separation, or a damaged V-section.
• With power disconnected, check that the belt is seated on the motor and drive pulleys and that it is not visibly slipping off.
• If the belt is damaged, inspect the visible pulleys and surrounding area for obstruction, misalignment, or signs of binding before installing a new belt.
• Do not operate the washer with panels removed or hands near moving components; other faults can produce similar symptoms.

Pro Tip

Part Details

Key Features

• Genuine Whirlpool OEM washer spin/drive belt
• Medium V-shaped belt
• Approximately 30 1/4 inches long and 1/2 inch wide
• Used on one- and two-speed washer drive systems
• Transfers motor power to the transmission/drive system
• Exact part identity supported by Whirlpool-associated parts databases and established appliance-parts retailers

Installation Notes

• Disconnect electrical power before servicing and restore all panels before operation.
• Installation requires access to the washer motor and drive/pump area; the exact access procedure varies by washer model.
• Remove the old belt only after confirming the belt routing and pulley arrangement for the specific washer model.
• Route the replacement belt over the correct pulleys and verify that it is seated properly before reassembly.
• Check pulley alignment and confirm that the belt moves freely without rubbing before operating the washer.
• Verify the appliance model before installation; a belt-related symptom does not by itself prove that the belt is the only failed component.

Verified Compatible Models

ALW110RAW, ALW210RAW, ALW210RMC, ALW210RMW, ALW410DAW, ALW430RAC, ALW430RAW, ALW432RAW, ALW450QAC, ALW450QAW, ALW480DAC, ALW480DAW, ALW540RAC, ALW540RAW, DLW330RAW

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.