Genuine OEM Replacement Part
WP3398095 Whirlpool Dryer Start Switch – Fix a Dryer That Won’t Start
Replaces 3398095
Whirlpool, Kenmore, Maytag, Roper
Push-to-Start Switch
When you press the start button and nothing happens — no hum, no drum movement, no response — the start switch is one of the first components to suspect. The start switch sends the signal to begin the motor cycle when pressed. When it fails, the dryer won’t start at all, even if every other component is functioning normally. The WP3398095 is the genuine OEM push-to-start switch for Whirlpool, Kenmore, Maytag, and Roper dryers, directly replacing 3398095.
⚠️ Pro tip: Before replacing the start switch, test it with a multimeter for continuity — it should show continuity when pressed and open when released. Also check the door switch, as a failed door switch produces identical symptoms. If both test bad, replace both at the same time to avoid a second teardown.
Common Symptoms This Fixes
- Dryer won’t start when the start button is pressed
- No response, hum, or drum movement when starting
- Dryer starts only intermittently or requires multiple presses
- Start button feels loose, stuck, or doesn’t click properly
- Dryer stops immediately after releasing the start button (on models requiring hold-to-run)
Part Details
-
Part Number: WP3398095
-
Replaces: 3398095
-
Type: Push-to-start switch
-
Compatible Brands: Whirlpool, Kenmore, Maytag, Roper, Estate, Inglis
Installation Notes
Difficulty: Easy — 15–20 minutes. Always unplug the dryer before servicing. The start switch is located on the control panel. Remove the control panel screws, disconnect the wiring harness from the old switch, and snap or screw the new switch into place. Reconnect the harness and reassemble. Test before closing up fully.
Why Order From XPart Supply?
- In stock for same-day shipping when ordered before 4PM
- Genuine OEM parts from trusted suppliers
- Fast fulfillment across Canada and the US
- Expert support — contact us to confirm compatibility
