GE Refrigerator Not Cooling or Displaying Errors? Control Board WR01F00221 — Fix Temperature Failures Fast

When a GE refrigerator stops cooling, displays error codes, or behaves erratically despite the compressor running, the main control board is the most common root cause. In most GE and Hotpoint refrigerators, the control board manages every major function — compressor cycling, defrost timing, fan control, and temperature regulation. When it fails, the refrigerator may stop cooling entirely, run continuously without reaching temperature, or display fault codes that cannot be cleared. ⚡ Common failure point in GE-built refrigerators and freezers. Part WR01F00221 is the genuine OEM replacement that restores full electronic control with a direct plug-in installation — no programming required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your GE or Hotpoint refrigerator powers on but is not cooling correctly
• ✔ The compressor, evaporator fan, and condenser fan have been confirmed operational
• ✔ Power supply to the unit is confirmed stable — no tripped breakers or voltage issues
• ✔ ONLY problem is temperature failure, error codes, or erratic operation — not a mechanical compressor failure

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Refrigerator not cooling or freezer not reaching set temperature
• Error or fault codes displayed on the control panel that won’t clear
• Compressor runs continuously without cycling off
• Refrigerator completely dead — no lights, no fans, no response
• Defrost system not activating, causing frost buildup on evaporator
• Intermittent cooling failures or random shutdowns

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this control board restores normal refrigerator operation immediately.

📦 Part Details

• Part Number: WR01F00221
• Type: Main Refrigerator Control Board — primary electronic controller for compressor, defrost, fans, and temperature regulation
• Replaces: 200D2260G008, 200D4854G022, 200D6221G005, 200D6221G010, 200D6221G014, WR09M00559, WR55X10699, WR9M525 — no modification required
• Brands: GE, General Electric, Hotpoint, RCA

⚙️ Installation

Skill Level: Moderate — 20 to 45 minutes. Disconnect power before servicing. The control board is typically located at the rear of the refrigerator behind an access panel or inside the fresh food compartment. Photograph all wire harness connections before removal, unplug each connector from the old board, mount the new board in the same location, and reconnect all harnesses in the original positions. Restore power and allow the unit to run through a full cooling cycle to confirm normal operation.

✓ Compatible Models

Confirmed compatible with GSHS6PGYAESS, GSR23YBWASS, GSRC3KLZAFWW, GTH18CBEERWW, GTS18IBRXRWW, GSRS3KLZAFSS, GSRS5KLZAFSS plus 60+ additional GE, Hotpoint, and RCA models. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages