The WW02F00900 is the OEM blower wheel for GE top-load and front-load dryers, replacing the discontinued WW02F00522, 234D2117P003, and WE16X23857. The blower wheel is responsible for drawing air through the drum and exhausting it through the vent — when it cracks, slips on the shaft, or accumulates lint buildup, drying performance drops and noise increases. This is a direct OEM replacement for a precise fit with no modifications required.

✓ Model-Specific Repair Pages

The blower wheel mounts directly onto the motor shaft and spins at high speed to move heated air through the drum and out the exhaust duct. A cracked or loose wheel causes the characteristic thumping or scraping noise that gets worse over time. Inspect the motor shaft hub carefully during installation — a worn hub will cause vibration even with a new wheel if not properly secured.

✓ Common Symptoms Fixed

• Loud rumbling, thumping, or scraping noise during operation
• Poor airflow or excessively long drying times
• Burning smell from lint buildup caused by restricted airflow
• Blower wheel slipping or spinning freely on the motor shaft
• Dryer running but clothes not drying

✓ Key Features & Specifications

• OEM part number: WW02F00900
• Replaces: WW02F00522, 234D2117P003, WE16X23857
• Direct OEM replacement — no modifications required
• Compatible brands: GE, General Electric, Hotpoint
• Barcode: 751492748441
• Repair time: Professional 30–45 min • DIY (Experienced) 45–60 min

✓ Buying Options

OEM (WW02F00900): The genuine GE factory blower wheel. Direct fit, full OEM specifications, and the only option currently listed for this part. No aftermarket alternative is available at this time.

✓ Replacement Part Numbers

• WW02F00900 (current OEM)
• WW02F00522 (superseded)
• 234D2117P003 (superseded)
• WE16X23857 (superseded)

✓ Installation Tips

• Unplug the dryer before beginning any disassembly.
• Remove the rear panel to access the blower housing.
• Detach the blower housing and carefully remove the old blower wheel using a socket wrench or pliers depending on model.
• Clean all lint and debris from the blower housing before installing the new wheel.
• Inspect the motor shaft hub for wear — a worn hub will cause vibration even after replacement if not properly secured.
• Align and tighten the new wheel securely onto the motor shaft, ensuring no wobble before reassembly.
• Run a test cycle after installation to confirm airflow is restored and noise is eliminated.