Whirlpool Dryer Won't Start, Controls Unresponsive, or Display Blank? Electronic Console Board W11378949 – Fix Control Panel Failure Fast

A Whirlpool dryer with an unresponsive control panel, blank display, buttons that won't register, or cycles that won't start or advance almost always has a failed electronic console board. In most Whirlpool WED and WGD series dryers, the electronic console board is the front-facing PCB that manages all cycle selection, display output, and user input from the control panel — when it fails, the dryer may appear powered but completely unresponsive, or may start a cycle and stop without completing it. When it fails, the display may go blank, show incorrect characters, or the touchpad may register no input despite the dryer having power. ⚡ Electronic console board failure is the most common cause of an unresponsive or dead control panel on Whirlpool WED560, WED5620, WGD560, and WGD5620 series dryers. Part W11378949 is the genuine OEM electronic console board that restores full control panel function and normal cycle operation immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your dryer is a compatible Whirlpool WED560, WED5620, WGD560, WGD5620, or YWED series model
• ✔ The dryer has power — drum light or other indicators confirm power is present
• ✔ The control panel is unresponsive or the display is blank despite confirmed power
• ✔ A 5-minute hard reset (unplug, wait, restore power) did not resolve the fault
• ✔ ONLY problem is control panel failure — not a thermal fuse, door switch, or main control board fault

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Dryer won't start — no response when Start button is pressed
• Control panel buttons unresponsive — no beep or display change on any button press
• Display blank or dark despite dryer having power
• Display showing incorrect characters or partial segments
• Cycle won't advance or complete — dryer stops mid-cycle without finishing
• Some buttons work but others don't — partial console board failure

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing the electronic console board restores full control panel function and normal cycle operation immediately.

📦 Part Details

• Part Number: W11378949
• Type: Dryer Electronic Console Board — Control Panel PCB / User Interface Assembly
• Replaces: OEM direct-fit board — supersedes W11296383, W11314470, W11321074 (no modification required)
• Brands: Whirlpool (WED560, WED5620, WGD560, WGD5620, YWED560, YWED5620 series)

⚙️ Installation

Skill Level: Easy to Moderate — 20–40 min DIY. Disconnect power at the breaker before beginning. Remove the top panel screws and lift the console to access the board behind the control panel fascia. Photograph all wire harness connector positions before disconnecting, transfer all connectors to the new W11378949 board in the same positions, and reinstall the console. Restore power and run a full test cycle to confirm all buttons, display, and cycle functions operate correctly.

💡 Pro Tip

Related repair guides and model hubs: Whirlpool Dryer Console Board W11378949, Whirlpool Dryer Won't Start, Whirlpool Dryer Parts, 7MWED5620HW0, WED560LHW0, WED5620HW0, WGD560LHW0, WGD5620HW0, YWED560LHW0, YWED5620HW0