Frigidaire EI24CD35RS3A Dishwasher Leaking: Safe Checks and Compatible Parts

Is your Frigidaire EI24CD35RS3A dishwasher leaking? Stop the dishwasher, switch off electrical power at the appropriate disconnect or breaker, and shut off the water supply if the leak is active. Do not reach into standing water while power may still be present. The leak may involve the door area, a hose or connection, or another internal component, so the location and timing of the water are important before choosing a replacement part.

For the verified Frigidaire EI24CD35RS3A fitment information available through XPart Supply, two relevant replacement products are listed: the A01256402 hose, sump, L=361 mm, water tank, and the 117158011 dishwasher door seal. These parts address different areas of the dishwasher. They should not be treated as interchangeable, and a leak symptom alone does not prove which component has failed.

Where is the Frigidaire EI24CD35RS3A dishwasher leaking?

Begin by identifying the first place water appears rather than the place where it finally collects. Water can travel along the base, insulation, cabinet, or floor, making the visible puddle misleading.

• Bottom of the door or front corners: Inspect the door seal area for visible displacement, damage, contamination, or an uneven seal. The verified door-seal option for this model is part number 117158011.
• Underneath the dishwasher or near the sump area: Look for moisture around accessible hose routing and connections. The verified hose option is part number A01256402, described as a sump hose, L=361 mm, water tank.
• Inside the tub after a cycle: Some water remaining inside may have more than one possible explanation. Do not assume that an internal water level by itself identifies a failed seal or hose.
• Near a supply or drain connection: Inspect only when the water supply is off and the appliance is safely isolated. A connection may need attention, but the verified product list here does not establish every possible source of a leak.

When does the leak occur during the cycle?

Timing can help narrow the inspection area, but it is not a guaranteed diagnosis. If possible, observe from a safe distance during a brief test only after the appliance has been made safe to inspect and there is no active electrical or flooding hazard.

• During filling: Check for water appearing around the water-entry path, tub area, or connections.
• During washing: Water escaping from the lower door area may point attention toward the door seal and the way water is being directed inside the tub.
• During draining: Inspect the sump and drain-path area for moisture, including the verified A01256402 sump hose location.
• After the cycle ends: Check whether the leak continues, whether water is pooled beneath the unit, and whether the first visible moisture came from the door or from underneath.

Could the door seal be causing the leak?

A damaged, displaced, dirty, or poorly seated door seal can allow water to escape at the lower door edge or front corners. With the dishwasher disconnected from power, inspect the seal around the door perimeter. Look for sections that are twisted, pulled out of position, split, hardened, or obstructed by residue. Also check that the door closes evenly without an obvious obstruction.

The verified replacement for the Frigidaire EI24CD35RS3A dishwasher door-seal fitment is 117158011. Before ordering, compare the complete model label on your appliance with EI24CD35RS3A and confirm that the replacement listing and part number match your repair need. A door leak can also have another cause, so replacing the seal without confirming the source may not resolve the symptom.

Could the sump hose be causing water underneath?

If water appears beneath the tub or around the sump area, inspect the accessible hose route and connection points after shutting off power and water. Look for a loose connection, visible split, abrasion, swelling, or evidence that water begins at the hose rather than running down from above. Avoid pulling on a hose or disturbing a connection if doing so could create a larger leak.

The verified hose for the Frigidaire EI24CD35RS3A is A01256402, listed as Hose, sump, L=361 mm, water tank. Its verified model fitment is the reason it is included for this appliance, but the symptom alone does not confirm that this hose is defective. Match the part number and description before purchase, and consider documenting the leak location with a photograph if the source is difficult to see.

What other components should be considered?

Several components can create a similar leaking symptom. Depending on the location and timing, the cause may involve the door-sealing area, a sump or hose connection, water movement inside the tub, or another water-path component. A spray arm that is damaged, obstructed, or directing water abnormally can contribute to water reaching an unexpected area, while a pump, sump, drain path, or water-supply connection may require further inspection.

These possibilities are inspection categories, not confirmed diagnoses or additional verified replacement recommendations for this model. The verified buyable products for this issue are limited to the A01256402 sump hose and 117158011 door seal. If you cannot safely identify the source, if water reaches wiring or electrical parts, or if the appliance continues to leak after isolation, stop troubleshooting and use a qualified appliance professional.

How can you check the model before ordering?

Find the appliance identification label and confirm the complete model number, including every letter and number: Frigidaire EI24CD35RS3A dishwasher. Then compare the required component and part number:

• A01256402 — Hose, sump, L=361 mm, water tank.
• 117158011 — Dishwasher door seal.

Do not rely only on a similar-looking appliance, a partial model number, or a general description such as “Frigidaire dishwasher hose.” Confirm both the model label and the part number before ordering. If the label is difficult to read, take a clear photo for your records and verify the listing details carefully.

Where can you find the verified parts for this model?

Use the Frigidaire EI24CD35RS3A dishwasher parts hub to review the model-specific fitment information. For the two verified products, see the A01256402 sump hose and 117158011 dishwasher door seal. Choose only after confirming the leak area, complete model label, and exact part number.

Frequently asked questions about a leaking EI24CD35RS3A

Should I keep running the dishwasher to find the leak?

No. Stop using it if water is escaping, isolate power safely, and shut off the water supply when appropriate. A professional can help if the source is not safely accessible.

Does water at the front always mean the door seal failed?

No. The 117158011 door seal is a verified fitment option, but water can be redirected or travel from another area. Inspect the first point of moisture before ordering.

Is A01256402 the correct hose for this model?

It is the verified sump-hose fitment listed for Frigidaire EI24CD35RS3A. Confirm the appliance label and the part number before purchase.

Can replacing one part guarantee the repair?

No. Multiple components can create similar symptoms, and a leak diagnosis depends on its location, timing, and condition. Confirm the source before replacing a component.