Whirlpool Corporation Washer lid switch assembly 285671, Replaces 285671VP, 3352629, 3352630, 3352631, 3352632, 3352634, 3355808, 8134

Top-load washer lid switch and wire-harness assembly. The switch detects whether the lid is open or closed and prevents spinning or agitation when the lid is not secured. The assembly includes a three-terminal harness.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Washer will not start or initiate the cycle
• Washer stops during the cycle when agitation or spin should begin
• Washer will not spin but may fill or agitate
• Intermittent operation when the lid is pressed or repositioned
• Washer may not drain if the lid-switch safety circuit is open

Check Before Replacing

• Unplug the washer before inspection or testing.
• Confirm the lid closes fully and that no clothing or debris prevents the lid strike from engaging the switch.
• Listen for consistent switch actuation when the lid closes; an absent or intermittent click can indicate a lid, strike, alignment, or switch problem.
• Inspect the visible harness and connector for loose connections, damaged insulation, or pulled wires.
• If qualified to perform electrical testing, test the switch for continuity only with the washer unplugged and using the appliance wiring diagram; do not bypass the safety switch.
• Rule out unrelated causes such as a kinked drain hose, clogged drain path, overloaded load, or unbalanced load before replacing the switch.

Pro Tip

Part Details

Key Features

• Genuine Whirlpool OEM washer lid switch and wire-harness assembly
• Three-terminal harness configuration
• Harness connector uses two round pins and one D-shaped pin
• Includes the switch assembly, wiring harness, installation instructions, and two zip ties
• Used as a lid-safety interlock for selected Whirlpool, Kenmore, KitchenAid, Roper, and Estate top-load washers

Installation Notes

• Disconnect electrical power before installation.
• Use the supplied installation instructions and route the replacement harness along the original path, securing it with the included zip ties or existing harness clips.
• Reconnect the harness firmly and reattach the ground connection where provided by the original assembly.
• Ensure the switch is positioned so the lid strike engages it correctly before restoring power.
• Do not operate the washer with the lid-safety switch bypassed.

Verified Compatible Models

11016101690, 11016202690, 11016502690, 11016502691, 11016502693, 11016602690, 11016602692, 11016872690, 11016872692, 11026051690, 11026058590, 11026058690, 11026071690, 11081862120, 11081862320

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.