The drum felt bearing is the rear support point for the entire drum — it cushions the drum’s back edge against the bulkhead and keeps it centred during rotation. When the felt wears through or the bearing surface glazes over, the metal drum edge contacts the cabinet directly, producing the high-pitched squeal or rhythmic scraping that customers mistake for a failing motor or belt. Replacing the W11035878 Dryer Drum Felt Bearing eliminates the metal-on-metal contact, restores quiet operation, and prevents the accelerated wear that a bare drum edge causes to the rear bulkhead.
⚠️ Symptoms of a Worn Drum Felt Bearing
- High-pitched squealing or squeaking throughout the entire dry cycle
- Rhythmic scraping or grinding noise that changes with drum speed
- Drum wobbles or feels loose when rotated by hand with the door open
- Visible wear marks or scoring on the rear drum edge or bulkhead
- Noise worsens as the dryer heats up (felt shrinks further as it dries out)
- Vibration or rattling transmitted through the cabinet during operation
✓ Part Details & Cross-References
- OEM Part Number: W11035878
- Replaces: 3406129, 692493, W10568603, W10663510, W10803476, W10887344, WPW10663510
- Compatible Brands: Whirlpool, Kenmore (electric and gas dryer models)
- Component Type: Dryer Drum Rear Felt Bearing / Drum Support Bearing
- Condition: OEM New — select variant above
- HS Code: 850990
With the drum out to replace the rear felt bearing, the front drum seal and drive belt are fully accessible at no extra disassembly cost. If the belt shows cracking or glazing, or the front seal is flattened, fitting all three wear items in one visit adds under 20 minutes and eliminates the two most common callbacks on this repair. A squealing dryer that gets a bearing-only fix and returns two months later for a belt is a preventable second service call.
⚙️ Installation Notes
- Skill Level: Intermediate — top panel, front bulkhead, and drum removal required
- Always disconnect power (and gas supply if applicable) before beginning any repair
- Support the drum as the front bulkhead is removed — the drum will drop without the front support
- Clean the rear bulkhead bearing surface thoroughly before fitting the new felt bearing
- Seat the new bearing evenly around the drum rear lip with no gaps; press firmly to ensure full contact
- Reassemble, reconnect power, and run a timed cycle to confirm quiet, smooth drum rotation
✓ Compatible Models
This drum felt bearing is compatible with hundreds of Kenmore electric and gas dryer models in the 110.6xxxx, 110.7xxxx, and 110.8xxxx series, as well as select Whirlpool-platform dryers. Confirm your full model number against the cross-reference list above or contact us to verify fitment before ordering.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
