Oven Not Heating Correctly? W11355250 Control Board – Fix Whirlpool Oven Failures Fast
If your Whirlpool oven won't heat, displays error codes, or has unresponsive controls, the control board is the most common culprit. In most Whirlpool and KitchenAid ovens, this is caused by a failed oven control board. When it fails, the oven may not respond to input, fail to reach set temperatures, or display persistent fault codes — leaving you unable to cook. ⚡ Common failure point in Whirlpool-built ovens. Part W11355250 is the genuine OEM replacement that restores full oven control, accurate temperature regulation, and normal operation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — oven powers on and the display lights up
- ✔ QUALIFIER 2 — the door latch, igniter, and heating elements test OK
- ✔ QUALIFIER 3 — power supply and wiring to the board confirmed OK
- ✔ ONLY problem is unresponsive controls, incorrect temperatures, or persistent error codes
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Oven won't heat or reaches wrong temperature
- Control panel buttons unresponsive or erratic
- Error or fault codes displayed on the panel (e.g. F1, F3, F5)
- Oven shuts off unexpectedly mid-cycle
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control board restores normal oven operation immediately.
📦 Part Details
- Part Number: W11355250
- Type: OEM Electronic Oven Control Board
- Replaces: W10871065
- Brands: Whirlpool, KitchenAid
While the oven is open, inspect the oven temperature sensor (probe). A faulty sensor is often mistaken for a bad control board — and replacing both at the same time saves a second service call if the sensor is borderline.
⚙️ Installation
Skill Level: MODERATE — 30–60 minutes. Disconnect power before servicing. Remove the rear panel or control console to access the board, disconnect the wire harness connectors, swap the board, and reassemble. No soldering required — all connections are plug-and-play.
✓ Compatible Models
Confirmed compatible with select Whirlpool and KitchenAid oven models that originally used part W10871065, plus additional models in the same platform family. Contact us to verify your model number before ordering.
💡 Pro Tip
Before replacing the control board, test the oven temperature sensor with a multimeter — it should read approximately 1,080–1,090 ohms at room temperature. A shorted or open sensor can mimic a dead control board and damage a new board if left in place. Replacing both together on the first visit is the professional move.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
