Washer Not Starting or Stopping Mid-Cycle? Control Board 5304511341 – Fix It Fast

If your Frigidaire or Electrolux washer won't start, stops mid-cycle, or displays error codes, the main control board is the most common culprit. In most front-load and top-load models, the control board manages every wash cycle, motor command, and sensor input. When it fails, the machine becomes unresponsive or behaves erratically. ⚡ High-failure component in Frigidaire-built washers. Part 5304511341 is the genuine OEM replacement that restores full washer operation without modification.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on but will not start a cycle
• ✔ Door latch and lid switch are confirmed working
• ✔ Water supply and drain hoses are clear and connected
• ✔ Motor and pump run normally when bypassed or tested
• ✔ ONLY problem is loss of cycle control, error codes, or unresponsive panel

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Washer won't start any cycle — most common complaint
• Cycle stops randomly mid-wash or mid-spin
• Control panel buttons unresponsive or erratic
• Washer fills with water but drum does not agitate or spin
• Error codes E10, E20, E40, or EF1 displayed repeatedly
• Machine runs continuously without completing a cycle

✔ If these symptoms match, the control board is the most likely failed component in the system.

✔ In most cases, replacing this control board restores normal washer operation immediately.

📦 Part Details

• Part Number: 5304511341
• Type: Main Electronic Control Board Assembly
• Replaces: OEM direct-fit control board — supersedes earlier Frigidaire and Electrolux board revisions (no modification required)
• Brands: Frigidaire, Electrolux, White-Westinghouse

⚙️ Installation

Skill Level: MODERATE — 30–60 minutes. Disconnect power before beginning. Remove the washer's rear or top panel to access the control board housing, disconnect the wiring harness connectors (photograph before removal), unscrew the board from its bracket, and install the new board in reverse order. Ensure all connectors are fully seated before restoring power.

✓ Compatible Models

Confirmed compatible with Frigidaire and Electrolux front-load and top-load washer models. Contact us to verify your model number before ordering.

💡 Pro Tip

Compatible Model Hubs: Frigidaire Washer Parts, Electrolux Washer Parts