5304527492 Frigidaire Temperature Probe for Ovens, Restores Accurate Temperature Regulation

🇺🇸 Matching U.S. Part Number: 5304527492

5304527492 is a genuine Electrolux/Frigidaire PT1000 oven-temperature probe used on select Frigidaire and Electrolux ranges. The probe measures the temperature inside the oven cavity and sends a changing resistance signal to the electronic oven control. The control uses this information to regulate the heating system and maintain the selected cooking temperature.

A defective probe or damaged probe circuit may contribute to inaccurate oven temperatures, unstable heat, overheating, long preheat times or temperature-related fault codes. Similar symptoms can also result from damaged wiring, a poor connector, a failed electronic control, defective heating components, incorrect oven calibration or a damaged door seal.

Is This the Right Part?

Confirm the complete range model before ordering. Other Electrolux-built appliances may use temperature probes with different resistance characteristics, connectors or mounting arrangements.

Common Symptoms

• Oven temperature higher or lower than the selected setting
• Unstable or fluctuating oven temperature during cooking
• Oven overheating or not reaching the selected temperature
• Long preheat times
• Temperature-related fault codes displayed on the control panel

Check Before Replacing

• Test the probe resistance with a multimeter — a PT1000 probe reads approximately 1000 Ω at 0°C and increases with temperature; compare against the service specification for this model
• Inspect the probe wiring and connector for damage, corrosion or loose pins before ordering
• Check oven calibration settings — a calibration offset may correct minor temperature inaccuracy without replacing the probe
• Inspect the bake and broil elements (or gas ignition system on gas models), electronic oven control, door seal and power supply before concluding the probe is defective

Part Details

Installation Notes

1. Disconnect electrical power before testing or replacing the probe.
2. Photograph the probe wiring, connector and mounting position before removal.
3. Compare the new probe with the original — confirm connector type and probe length before installation.
4. Inspect the wiring harness and connector pins for damage during the repair.
5. Restore power and verify oven temperature accuracy after installation.

Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.

Verified Compatible Models

ECFD3068AS, ECFD3068ASA, ECFG3068ASA, ECFI3068ASA, ECFI3668ASA, PCFD3668AFA, PCFD3670AFA, PCFI3668AFA, PCFI3670AFA

Fitment reminder: Match the complete model number, including suffixes and revision digits, before ordering.