Freezer Not Staying Cold? Door Gasket 5304528904 – Fix Warm Freezer Fast

If your Frigidaire freezer is losing temperature, frosting up excessively, or running constantly, a failed door gasket is the most likely cause. In most Frigidaire and Electrolux freezers, the door gasket creates the airtight seal that keeps cold air in and warm air out. When it fails, warm humid air enters the freezer continuously, causing frost buildup, temperature swings, compressor overrun, and spoiled food. ⚡ One of the most common failure points in Frigidaire-built upright and chest freezers. Part 5304528904 is the genuine OEM replacement gasket that restores a factory-tight seal with no modifications required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Freezer powers on and compressor runs normally
• ✔ Evaporator fan and defrost system are functioning
• ✔ Door closes fully and latch engages
• ✔ Door hinges are straight and undamaged
• ✔ ONLY problem is warm temperature, frost buildup, or visible gasket damage (tears, gaps, hardening)

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Freezer not cold enough or temperature rising — most common complaint
• Excessive frost or ice buildup on interior walls
• Freezer running constantly or compressor cycling too frequently
• Visible tears, cracks, or gaps in the door seal
• Condensation or moisture around the door frame
• Dollar bill test fails — paper slides out easily when door is closed

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this door gasket restores proper temperature and eliminates frost buildup immediately.

📦 Part Details

• Part Number: 5304528904
• Type: Freezer door gasket / door seal
• Replaces: OEM direct-fit door gasket — supersedes 5304505772 (no modification required)
• Brands: Frigidaire, Electrolux, Kenmore

⚙️ Installation

Skill Level: EASY — 20–30 minutes. No need to disconnect power for this repair, but avoid leaving the door open longer than necessary. The old gasket pulls out of the door liner channel — work around the perimeter and press the new gasket firmly into the retainer groove, starting at the corners. Allow the gasket to warm to room temperature before installation for easier fitting, and let it set for a few hours before checking the seal.

✓ Compatible Models

Confirmed compatible with select Frigidaire, Electrolux, and Kenmore upright freezer models. Contact us to verify your model number before ordering.

💡 Pro Tip