LG Dryer Not Starting or Showing Error Codes? Main PCB EBR85130511 – Fix Control Board Fast

When your LG dryer won't start, displays persistent error codes, stops mid-cycle, or loses control of heat and timing, the main PCB assembly is the most likely cause. In most LG-built electric dryers, the main PCB is the central control board that manages every dryer function — motor start, heat relay, cycle timing, sensor inputs, and user interface — when it fails, the dryer may refuse to start, run partial cycles, display fault codes, or behave unpredictably. ⚡ Common failure point in LG dryers after power surges or component failures. Part EBR85130511 is the OEM main PCB assembly that restores full electronic control and normal dryer operation, available in OEM New and tested Used condition.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your dryer powers on — display lights up or responds to button presses
• ✔ Basic components (door switch, thermal fuse, motor) have been tested and confirmed good
• ✔ Power supply is confirmed OK — correct voltage at the outlet, no tripped breakers
• ✔ The issue is not a single component failure (heating element, thermistor) already ruled out
• ✔ ONLY problem is no start, persistent error codes, erratic cycling, or loss of heat/timing control

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Dryer won't start — buttons unresponsive or cycle won't initiate
• Persistent error or fault codes on the display that won't clear
• Dryer starts but stops mid-cycle without completing
• Heat not cycling correctly — runs too hot, too cold, or not at all
• Cycle timer not advancing — dryer runs indefinitely or stops too early
• Control panel buttons work intermittently or not at all

✔ If these symptoms match after ruling out individual component failures, the main PCB is the most likely cause.

✔ In most cases, replacing this PCB assembly restores full dryer operation immediately.

📦 Part Details

• Part Number: EBR85130511
• Type: Dryer Main PCB Assembly (primary electronic control board)
• Replaces: OEM direct-fit main PCB for LG DLE3095W and DLE3500W dryer models (no modification required)
• Brands: LG
• Options: OEM New · Used (tested)

⚙️ Installation

Skill Level: Moderate — 30–45 minutes. Disconnect power at the breaker or unplug the dryer before beginning. Access to the main PCB typically requires removing the rear panel or control console depending on your model — photograph all wire harness connections before disconnecting. Transfer connectors one at a time to the new board to avoid mis-wiring, then reassemble in reverse order. Restore power and run a test cycle to confirm all functions operate correctly.

✓ Compatible Models

Confirmed compatible with LG DLE3095W and DLE3500W electric dryer models. Contact us to verify your model number before ordering.

🔗 Model Hub Pages

No model-specific hub pages linked yet — contact us with your model number and we'll point you to the right parts breakdown.

💡 Pro Tip