Refrigerator Not Cooling? Compressor Assembly 5304530136 — Fix It Fast

If your Frigidaire refrigerator is running but not cooling, or the compressor won't start at all, the compressor assembly is the most critical component to diagnose. In most Frigidaire and Electrolux refrigerators, a failed compressor results in the unit running continuously without reaching temperature, or shutting off entirely and warming up. When it fails, food spoils, the freezer loses temperature, and the fridge may cycle on and off rapidly or not at all. ⚡ High-failure component in Frigidaire-built refrigerators — especially units 7–12 years old. Part 5304530136 is the genuine OEM replacement compressor assembly that restores full refrigeration capacity and proper temperature control.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ The refrigerator powers on — interior light works and fans run
• ✔ The condenser coils are clean and airflow is unobstructed
• ✔ The start relay has been tested and confirmed failed or the compressor won't start with a known-good relay
• ✔ ONLY problem is the fridge not cooling or the compressor not running/cycling off on overload

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Refrigerator runs continuously but never reaches set temperature
• Compressor clicks on and then immediately shuts off (overload tripping)
• Freezer and fridge both warming up despite fans running normally
• Compressor is completely silent — no hum, no vibration

✔ If these symptoms match after ruling out the start relay and condenser coils, the compressor is the confirmed failed component.

✔ Replacing the compressor assembly restores full refrigeration and freezer performance.

📦 Part Details

• Part Number: 5304530136
• Type: OEM Refrigerator Compressor Assembly
• Brands: Frigidaire, Electrolux
• Weight: 25 lbs

⚙️ Installation

Skill Level: ADVANCED — 2–4 hours. Refrigerant certification required. Disconnect power before servicing. Compressor replacement requires recovering existing refrigerant (EPA 608 certification required), removing the old compressor, brazing in the new unit, evacuating the system to deep vacuum, and recharging with the correct refrigerant type and weight. This is not a DIY repair — a certified appliance technician is required.

✓ Compatible Models

Compatible with select Frigidaire and Electrolux refrigerator models. Contact us to verify your model number before ordering — compressor compatibility must be confirmed against your specific model and refrigerant type.

💡 Pro Tip

✓ Shop by Appliance Type