LG Washer Leaking Water from the Door? Door Gasket MDS66290824 – Stop Leaks Fast
An LG front-load washer that leaks water from the door, leaves puddles on the floor, or shows visible tears or mold in the door seal almost always has a failed door gasket. In most LG front-load washers, the door gasket (also called the door boot seal) is the only barrier between the drum and the outside of the machine — it creates a watertight seal every time the door closes. When the rubber cracks, tears, or develops holes from age, sharp objects, or mold damage, water escapes during every wash cycle. ⚡ The door gasket is the most common cause of front-load washer door leaks in LG machines. Part MDS66290824 is the genuine OEM LG replacement that restores a complete watertight seal immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer is an LG front-load model
- ✔ The washer fills, agitates, and drains normally — pump and hoses are not the issue
- ✔ Water is leaking specifically from the door area — not from the back or bottom of the machine
- ✔ ONLY problem is water on the floor in front of the washer during or after a cycle
Not sure? Send us your model number — we’ll confirm before you order.
🔧 Common Symptoms
- Water leaking from the door during wash or spin cycles
- Puddles on the floor in front of the washer after a cycle
- Visible tears, cracks, or holes in the door boot seal
- Black mold or mildew buildup in the gasket folds that can’t be cleaned out
- Musty smell from the washer that persists after cleaning
- Door not sealing fully — gasket not making contact around the full perimeter
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing the door gasket eliminates leaks and restores a clean, watertight seal immediately.
📦 Part Details
- Part Number: MDS66290824
- Type: Front-Load Washer Door Gasket / Door Boot Seal — OEM LG rubber door seal assembly
- Replaces: MDS66290803 — direct drop-in, no modification required
- Brands: LG
While the gasket is out, inspect the door latch and strike for wear or misalignment — a door that doesn’t close squarely accelerates gasket wear and can cause the new seal to fail prematurely. Also clean the drum opening and gasket channel thoroughly before installing the new seal to ensure a proper seat.
⚙️ Installation
Skill Level: Moderate — 45–60 minutes. Disconnect power before servicing. Open the washer door and peel the old gasket out of the front panel retaining ring and drum lip. Clean the mounting channel thoroughly. Seat the new MDS66290824 gasket into the drum lip first, working around the full perimeter, then press the outer retaining ring back into the front panel groove. Restore power and run a short cycle to confirm no leaks.
💡 Pro Tip
A small amount of dish soap applied to the gasket lip makes seating the retaining ring significantly easier and prevents the rubber from folding or bunching during installation. Work around the ring in small sections rather than trying to press it in all at once — this prevents gaps that cause leaks at the seam.
Contact us to verify your LG washer model number before ordering.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
