WASHER WILL NOT START OR RESPOND TO CONTROLS
Whirlpool Washer Main Electronic Control Board W11513246, Replaces W11428994, Fixes Washer will not start or respond to controls
Whirlpool ACU (appliance control unit) program assembly / main electronic control board for select washers. It manages core washer operations including filling, washing, draining, and spinning.
Part W11513246Replaces W11428994Whirlpool
Whirlpool ACU (appliance control unit) program assembly / main electronic control board for select washers. It manages core washer operations including filling, washing, draining, and spinning.
Is This the Right Part?
Part NumberW11513246
ReplacesW11428994
ManufacturerWhirlpool
Appliance TypeWasher
Part TypeMain Electronic Control Board
✅ Cross Reference Information
Current Part NumberW11513246
ReplacesW11428994
Common Symptoms
- Blank or intermittent control panel
- Cycle stops or fails to advance
- Washer will not drain or spin
- Washer does not fill properly
- Unpredictable fill, wash, drain, or spin operation
- Persistent control-related error codes
Check Before Replacing
- Verify the washer has the correct incoming power before identifying the control board as faulty.
- Inspect the board and accessible wiring connectors for visible burn marks, damage, looseness, or corrosion with power disconnected.
- Check the lid-lock assembly and wiring connections because a lid-lock fault can prevent normal cycling.
- Run the washer’s model-specific service diagnostic cycle when available and compare the results with the applicable technical sheet.
- Compare the installed board’s part number and connector arrangement with the replacement before ordering.
Pro Tip
A main-control symptom can also originate in the power supply, lid lock, wiring harness, user interface, drain system, motor circuit, or water valves; confirm those areas before replacing the board.
Part Details
Part NumberW11513246
Part TypeMain Electronic Control Board
ManufacturerWhirlpool
Appliance TypeWasher
Primary FunctionControls and sequences the washer’s major electrical operations, including the drive motor, drain motor, water valves, and cycle progression.
Cross ReferencesW11428994
Key Features
- Genuine Whirlpool OEM washer main control board
- Programmed appliance control-unit assembly for select Whirlpool-family top-load washers
- Controls power and sequencing for the drive motor, drain motor, water valves, and other washer functions
- Replaces Whirlpool part number W11428994
Installation Notes
- Disconnect electrical power before servicing the washer.
- Handle the electronic board by its edges and protect it from static discharge.
- Photograph or label wiring locations before disconnecting connectors, then match the replacement board’s connector layout.
- After installation, run the applicable model-specific calibration or diagnostic cycle when required by the service documentation.
- Use the washer’s model-specific service information if programming, calibration, or diagnostic procedures are required.
Verified Compatible Models
CAW45125LW0, WTW5010LW0, WTW5015LW0, WTW5057LW0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
