Whirlpool Washer Electronic Control Board / Programmable ACU Assembly W11543994

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Washer won't start or turn on
• Washer completely dead — no lights, no response
• No response when pressing buttons
• Control panel lights up but washer won't start
• Error codes displayed (F# E# codes)
• Error code F0 E2 (control board communication error)
• Error code F0 E5 (control board failure)
• Error code F5 E2 (lid lock error when lock is good)
• Error code F7 E1 (motor/shifter error when motor is good)
• Error code F7 E5 (shifter fault)
• Error code F3 E1 (pressure switch error when sensor is good)
• Error code F8 E1 (water supply error when valves are good)
• Multiple error codes appearing randomly
• Washer stops mid-cycle
• Washer won't advance to next cycle
• Cycle starts but doesn't complete
• Washer stuck on sensing
• Erratic behavior — starts and stops randomly
• Control panel lights flicker or blink
• Buttons work intermittently
• Washer fills but won't agitate or spin
• Washer drains but won't spin
• Lid lock engages but cycle won't start
• Burning smell from control area (indicates board damage)
• Washer runs continuously — won't shut off

Pro Tip

Part Details

Installation Notes

• Unplug the washer
• – Disconnect power from the outlet. Wait 1–2 minutes to allow capacitors to discharge.
• Turn off water supply
• – Close both hot and cold water valves (optional but recommended).
• Access the control board
• – The control board is typically located inside the control console at the top of the washer:Remove the screws at the back of the control console (usually 2–3 Phillips screws).Tilt the console forward or lift it up to access the control board inside.Some models may have the board in a rear panel — remove the rear access panel if needed.
• Take photos
• – Document all wire harness connections before disconnecting anything. Label wires if helpful.
• Disconnect wire harnesses
• – Carefully unplug all wire connectors from the control board. Pull connectors straight off — don't pull on wires. Note: some connectors have locking tabs that must be pressed to release.
• Remove mounting screws or clips
• – Unscrew the screws or release the clips holding the control board to its mounting bracket or housing.
• Remove old control board
• – Take out the failed control board assembly.
• Transfer housing if needed
• – If the new board doesn't include the plastic housing/enclosure, carefully transfer it from the old board.
• Install new control board
• – Position the new W11543994 board and secure with mounting screws or clips.
• Reconnect all wire harnesses
• – Plug each connector back into its corresponding port on the new board. Ensure firm connections and that locking tabs click into place.
• Double-check connections
• – Verify all connectors are fully seated and match your photos.
• Reassemble control console
• – Replace the control console cover and secure with screws.
• Restore power
• – Plug the washer back in.
• Clear error codes (if needed)
• – Some models may require clearing stored error codes. Unplug for 1 minute, then plug back in.
• Run a calibration cycle (if required)
• – Some models require a calibration cycle after control board replacement. Consult your model's tech sheet (usually inside the console or cabinet) for specific instructions.
• Test operation
• – Run a complete wash cycle to verify all functions work properly — sensing, fill, agitate, drain, and spin.

Verified Compatible Models

MVW6230HC0, MVW6230HC1, MVW6230HW0, MVW6230HW1, MVW6230RHW0, MVW6230RHW1

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.