Whirlpool Refrigerator Condenser Fan Motor W11613295, Replaces W11387394, W11505534, W11373924, W10909377, W11123104, W11117459, W10239053, W10609117, 12825101, WPW10239053

Whirlpool OEM refrigerator condenser fan motor, rated 115 VAC and 1090 RPM. The motor circulates air across the condenser and compressor area and may also assist with drain-pan water evaporation.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Refrigerator or freezer temperatures are too warm
• Noisy, vibrating, or grinding sound from the condenser-fan area
• Compressor overheats or shuts down after limited cooling
• Refrigerator runs continuously while cooling poorly

Check Before Replacing

• Disconnect electrical power before inspection.
• Check the condenser-fan blade and surrounding area for obstructions, heavy dust buildup, or physical damage.
• With power disconnected, rotate the fan blade by hand; it should turn freely without binding or excessive wobble.
• Inspect the motor connector and visible wiring for looseness, discoloration, damaged insulation, or corrosion.
• If appropriate for the appliance service documentation, test the disconnected motor for continuity; lack of continuity supports a motor fault but does not by itself prove the complete cooling-system diagnosis.

Pro Tip

Part Details

Key Features

• Whirlpool genuine OEM condenser fan motor
• 115 VAC rating
• 1090 RPM specification
• Designed to circulate air across the condenser and compressor
• White motor housing; approximately 4 inches long, 3 inches wide, and 3.5 inches thick
• Used in selected frost-free refrigerators and some ice-making appliances

Installation Notes

• Unplug the refrigerator before removing the rear access panel or disconnecting the motor.
• The motor is accessed from the rear/bottom condenser-fan area on applicable appliances.
• Disconnect the motor connector before removing the motor.
• Remove the fan blade and motor mounting hardware only as required by the appliance design; retain and reuse compatible hardware unless the model-specific instructions state otherwise.
• Install the replacement in the original orientation, fully seat the fan blade on the shaft, reconnect the connector, reinstall the access panel, and confirm fan operation after restoring power.
• Use the appliance’s model-specific service information because access, mounting-hole count, and connector orientation can vary.

Verified Compatible Models

7MI2569VEM3, ABB192ZDEW, ABB1924WED0, ABB1924WEQ0, ABB2221WEW0, ABB2224BRW02, ABB2522FEW2, ABD2233DEW, ABD2533DEQ, ABD2533DES, ABL1922FES5, ABL2222FES4, ABR192ZFES12, ABR1922FES6, ABR2527FES12, GI15NDXZB2, GI15NDXZQ2, GI15NDXZS2, GI15PDXZS1, WUI75X15HB00, WUI75X15HW00, WUI75X15HZ00, WUI95X15HZ00

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.