Stand Mixer Bowl Cracked, Dented, or Missing? Mixer Bowl W11752234 — Fix It Fast
A cracked, warped, or missing stand mixer bowl makes your KitchenAid unusable for any mixing task — and a damaged bowl can contaminate food or cause the mixer to run off-balance. In most KitchenAid and Whirlpool stand mixers, bowl failure is caused by impact damage, stress fractures from thermal shock, or a bowl that has simply gone missing. When it fails or is absent, the mixer cannot be used safely, attachments have nothing to seat against, and the locking mechanism won’t engage properly. ⚡ The most-replaced accessory on KitchenAid bowl-lift and tilt-head stand mixers. Part W11752234 is the genuine OEM 6-quart stainless steel replacement bowl that seats and locks correctly, restoring full mixer function immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your stand mixer powers on and the motor runs normally
- ✔ The bowl-lift mechanism or tilt-head lock is intact and undamaged
- ✔ Your mixer uses a 6-quart bowl (confirm by checking your model number)
- ✔ ONLY problem is a cracked, damaged, or missing stainless steel bowl
Not sure? Send us your model number — we’ll confirm the correct bowl size and fit before you order.
🔧 Common Symptoms
- Bowl is cracked, dented, or warped and no longer seats flush
- Bowl locking tabs are broken and the bowl won’t lock into the mixer
- Bowl was lost, damaged in a move, or broken in a drop
- Mixer runs but vibrates excessively because the bowl isn’t seating correctly
✔ If these symptoms match, this is the correct replacement component.
✔ In most cases, swapping in this bowl restores full mixer function immediately.
📦 Part Details
- Part Number: W11752234
- Type: 6-Quart Stainless Steel Stand Mixer Bowl — OEM KitchenAid / Whirlpool
- Replaces: WPW10245586, W10245586 — no modification required
- Brands: KitchenAid, Whirlpool
If the bowl was damaged in a drop or impact, inspect the bowl-lift lever and bowl locking pins for bending or wear — a damaged lift mechanism will crack a new bowl over time. Also consider adding a pouring shield / splash guard if you don’t already have one; it prevents the kind of impact and thermal shock that causes most bowl failures.
⚙️ Installation
Skill Level: EASY — Under 2 minutes. No tools required. For bowl-lift models: set the bowl onto the lift pins with the handle facing left, then raise the lift lever to lock it in place. For tilt-head models: tilt the head back, set the bowl onto the bowl pin, and rotate clockwise until it locks. Run the mixer briefly at low speed to confirm the bowl is seated and stable before use.
✓ Compatible Models
Confirmed compatible with select KitchenAid and Whirlpool 6-quart bowl-lift and tilt-head stand mixer models. Contact us to verify your model number before ordering.
💡 Pro Tip
KitchenAid makes stand mixer bowls in 4.5-quart, 5-quart, 5.5-quart, 6-quart, and 7-quart sizes — and they are NOT interchangeable. The locking tabs and bowl diameter differ between sizes. Check the model number on the bottom of your mixer before ordering to confirm you need the 6-quart bowl. If you’re unsure, send us your model number and we’ll confirm the correct fit.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
