When your Whirlpool washer won't start, freezes partway through a cycle, or displays error codes you can't clear, the electrical control board is a primary suspect. The W11780162 is the direct OEM replacement PCB that restores full cycle coordination — from start and agitation through rinse, drain, and spin — so your machine runs reliably again without the cost of a full console replacement.

✓ Model-Specific Repair Pages

Don't see your model? Contact us and we'll confirm compatibility before you order.

✓ Common Symptoms Fixed

This electrical control board addresses the most common failure modes in affected Whirlpool washers: washer won't power on or start a cycle, washer starts then stops mid-cycle, display shows fault or error codes that won't clear, washer stuck on one cycle and won't advance, unresponsive or erratic control panel behavior, and door lock signal failures causing cycle interruptions.

✓ Key Features & Specifications

Part Number: W11780162
Part Type: Washer Electrical Control Board (PCB)
Brand: Whirlpool
Fit Type: OEM Direct Replacement
Functions Controlled: Cycle timing, agitation, rinse, drain, spin, door lock signaling, fault code management
Connector Layout: Matches original wiring harness positions for straightforward swap
Construction: Built to OEM specifications, rated for laundry room temperature and humidity conditions
ESD Protection: Handle with anti-static precautions during installation

✓ Buying Options

OEM / New — The genuine Whirlpool W11780162 electrical control board, sourced to OEM specifications. Exact connector layout, mounting points, and control logic as the original. Best choice when you need a guaranteed fit and long-term reliability.

These aftermarket replacement parts are not affiliated with, sponsored by, or endorsed by Whirlpool or any OEM manufacturer.

✓ Replacement Part Numbers

W11780162 (OEM) | W11780162XP (aftermarket cross-reference)

✓ Installation Tips

Always disconnect power and unplug the washer before starting. Discharge any capacitors on the old board before handling. Use anti-static precautions — handle the PCB by its edges only. Photograph all wiring harness connections before disconnecting them from the old board, then reconnect in the same positions on the new W11780162. Carefully align and seat all harness connectors — avoid forcing plugs to prevent pin damage. Inspect door lock switches and actuator mechanisms and replace if worn, to ensure proper cycle progression. Keep the work area dry and free of conductive debris. After installation, run a short test cycle (fill, agitate, drain, spin) before committing to a full load. If fault codes persist after replacement, check upstream components — inlet valves, lid switch, door lock, and wiring harness — for secondary faults.