DRYER HAS NO INCOMING POWER BECAUSE THE TERMINAL-BLOCK CONNECTION IS LOOSE OR DAMAGED
Whirlpool Corporation Dryer Terminal Block Screw Kit 279393, Fixes Dryer has no incoming power because the terminal-block connection is loose or damaged
Genuine OEM terminal block screw and nut kit for an electric dryer power-cord connection.
Part 279393Whirlpool Corporation
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number279393
ManufacturerWhirlpool Corporation
Appliance TypeDryer
Part TypeTerminal Block Screw Kit
Common Symptoms
- Dryer does not receive power due to a loose or damaged terminal-block connection
- Burned, loose, or missing terminal-block screws or nuts
Check Before Replacing
- Disconnect electrical power at the circuit breaker before inspection.
- Inspect the dryer terminal block and its screws/nuts for looseness, burning, corrosion, or missing hardware.
- Verify that the power-cord wires are securely attached to the terminal block; do not diagnose the kit as defective solely from a no-start condition.
Pro Tip
Inspect the terminal block itself and the power cord for heat damage before replacing only the screw kit.
Part Details
Part Number279393
Part TypeTerminal Block Screw Kit
ManufacturerWhirlpool Corporation
Appliance TypeDryer
Primary FunctionSecures the dryer wiring to the terminal block.
Installation Notes
- Disconnect the dryer from electrical power at the circuit breaker before installation.
- Access to the terminal block is at the rear of the dryer behind its cover plate.
- Replace the terminal block or power cord as needed if either shows heat damage.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
