OVEN TEMPERATURE IS INACCURATE
Whirlpool Range Oven temperature sensor WP7430P044-60, Fixes Oven temperature is inaccurate
Genuine Whirlpool oven temperature sensor/probe that measures the temperature inside the oven cavity. Manufacturer parts lists identify the component as “Sensor, Oven.”
Part WP7430P044-60Replaces 7430P044-60, 74010385, 74003095Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberWP7430P044-60
Replaces7430P044-60, 74010385, 74003095
ManufacturerWhirlpool
Appliance TypeRange
Part TypeOven temperature sensor
✅ Cross Reference Information
Current Part NumberWP7430P044-60
Replaces7430P044-60, 74010385, 74003095
Common Symptoms
- Oven temperature runs consistently too hot or too cool.
- Oven may stop heating or regulate incorrectly because the control receives an implausible sensor signal.
- An oven-temperature sensor open/short fault may be displayed, depending on the range model.
- Temperature-related baking problems can occur when sensor resistance is substantially outside specification.
Check Before Replacing
- With power disconnected, inspect the sensor wiring and connector for loose terminals, corrosion, heat damage, or broken wires.
- With the sensor disconnected and the oven at room temperature, measure resistance across the sensor circuit; approximately 1050–1100 ohms is a commonly documented room-temperature range for this part family.
- Compare the measured resistance with the model-specific service data or temperature-resistance chart; an open circuit, short circuit, or substantially out-of-range reading indicates a sensor or circuit problem, but does not by itself prove the control board is good or bad.
- If the sensor reading is normal, inspect the wiring path and connector continuity before condemning the electronic control.
Pro Tip
Test the sensor and its wiring before replacing the control board. A room-temperature reading near 1090 ohms is commonly expected, while an open, shorted, or substantially different reading supports further sensor-circuit diagnosis.
Part Details
Part NumberWP7430P044-60
Part TypeOven temperature sensor
ManufacturerWhirlpool
Appliance TypeRange
Primary FunctionMeasures oven-cavity temperature and sends a resistance-based signal to the range's electronic control so heating can be regulated.
Installation Notes
- Disconnect electrical power to the range before servicing.
- Allow the oven to cool before accessing the sensor.
- Remove and install the sensor using the model-specific service instructions; the sensor is mounted at the oven cavity and connects to the range wiring.
- Inspect the connector and harness for heat damage or corrosion while the sensor is accessible.
- Do not rely on a generic installation procedure if the replacement connector or wiring arrangement differs; verify the model-specific instructions before making any wiring repair.
- Restore power only after the sensor and wiring are secured, then verify oven operation without bypassing safety devices.
Verified Compatible Models
JJW7530DDB19, JJW7530DDS19, JJW7530DDW19, KDRS505XSS01, MER6765BAS18, MER6772BCQ, MER6775BAB17, MER6775BAF17, MER6775BAS18, MER6775BCB17, MER6775BCS17, MER6775BCW17, MGT8655XB02, MGT8655XS02, MGT8655XW02
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
