Whirlpool Washer Drain Hose WPW10114608, Replaces W10114608, W10225577, 8540011

OEM drain hose that carries wastewater from the washer drain pump to the household drain. The part is used on select front-load washers.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Puddles or water spray near the washer base during the drain portion of a cycle
• Slow or incomplete draining when the hose is kinked, restricted, or damaged
• Visible cracking, splitting, abrasion, or a detached hose connection
• Water siphoning or repeated filling and draining when the drain hose is installed incorrectly

Check Before Replacing

• With the washer unplugged and water supply turned off, visually inspect the hose for cracks, splits, abrasion, kinks, or crushed sections.
• Check that both hose connections are fully seated and that the existing clamps or retaining hardware are secure.
• If safe to do so, observe the washer during a drain phase from a dry location to identify whether water appears at the hose or its connections; do not reach into or move the operating appliance.
• Verify the household drain setup against the washer installation instructions: the hose should not be excessively inserted or sealed airtight in the standpipe, and it should be routed without kinking.
• Before disconnecting the hose, account for residual water and place absorbent material where appropriate; do not remove panels or connections unless the washer is unplugged and the procedure is supported by the model's service documentation.

Pro Tip

Part Details

Key Features

• Genuine Whirlpool OEM drain hose
• Designed for select front-load washers
• Connects the washer drain pump outlet to the household drain path
• Replaces Whirlpool numbers W10114608, W10225577, and 8540011

Installation Notes

• Disconnect electrical power before servicing the hose; residual water may remain in the hose or washer.
• Route the replacement hose through the same clips and openings as the original, avoiding sharp bends, pinching, and cabinet abrasion.
• Seat the hose fully on its connector and secure it with the applicable clamp or retaining hardware; do not substitute an unverified attachment method.
• Follow the specific washer model's installation or service instructions for access-panel removal, hose routing, drain height, and standpipe insertion depth.
• After installation, run an appropriate drain or rinse test while checking for leaks and proper drainage before returning the washer to its final position.

Verified Compatible Models

11046462500, 11046462501, 11046472500, 11046472501, 11047511700, 11047511701, 11047511702, 11047512600, 11047512601, 11047512602, 11047512603, 11047512604, 11047512605, 11047531700, 11047531701

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.