Whirlpool Dishwasher Dishrack Stop Clip / Upper Dishrack Slide Rail Stop WPW10195622, Replaces W10195622

Upper dishrack stop clip that prevents the dishwasher’s upper rack from sliding completely off its slide rail. The clip is sold individually and may be used on either the left or right side, according to retailer technical guidance.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Upper rack falls off or pulls out of the slide rail
• Rack track is not retained at the rear
• Dishrack movement is uncontrolled when pulled outward
• Rack-stop clip is visibly broken, missing, or damaged

Check Before Replacing

• With the dishwasher empty and the door open, gently pull the upper rack outward and verify that the stop clip limits travel and retains the rail.
• Visually inspect the clip for cracks, breakage, looseness, or absence; compare the affected side with the corresponding stop on the other side when accessible.
• Confirm that the clip is installed on the correct end of the rail and that the rail is seated before concluding that the clip is defective.
• Do not operate the dishwasher with the upper rack or rail unsecured; verify that the rack rolls normally after any replacement.

Pro Tip

Part Details

Key Features

• Whirlpool OEM upper dishrack stop clip
• Gray plastic stop/retainer
• Sold individually
• May be used on the left or right side, depending on the dishwasher design
• Designed to retain the upper-rack slide rail and limit rack travel
• Approximately 1-1/4 inches wide according to retailer specification

Installation Notes

• Disconnect power before servicing the dishwasher and follow the appliance’s service or repair instructions.
• Remove or reposition the upper rack only as needed to access the rail stop; support the rack and rail to prevent them from dropping.
• For designs using a removable stop clip, release the existing clip from the rail, seat the rail correctly, and install the replacement stop in the same location.
• A small flat-blade screwdriver may be used where required to release the existing clip; do not force the rail or plastic stop.
• After installation, manually slide the upper rack several times to confirm that the stop retains the rail and that the rack moves without binding.

Verified Compatible Models

7WDT770PAYW3, 7WDT790SAYM0, 7WDT790SAYM2, 66512776K310, 66512776K311, KUDS30IXWH0, KUDS30IXWH1, KUDS30IXWH2, KUDS30IXWH3, KUDS30IXWH4, KUDS30IXWH6, KUDS30IXWH7, KUDS30IXWH8, KUDS30IXWH9, KUDS30IXWHA

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.