Burner Not Igniting? Electrode & Igniter Harness WS01F08076 – Fix Ignition Failures Fast
When your GE gas range burners click continuously, fail to spark, or light inconsistently, the ignition system has failed and cooking becomes unreliable. In most GE gas ranges, this is caused by a failed electrode and harness assembly. When it fails, one or more burners will not ignite, may click endlessly without lighting, or produce a weak spark that cannot sustain a flame. ⚡ Common failure point in GE-built 30" gas ranges and stoves. Part WS01F08076 is the genuine OEM replacement that restores reliable spark ignition across all burners to factory performance.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your range powers on and the gas supply is confirmed open
- ✔ Other burners or oven functions work correctly (or all burners are affected equally)
- ✔ Gas pressure and supply line confirmed OK — no gas supply issue
- ✔ ONLY problem is burners not sparking, clicking without igniting, or weak/intermittent ignition
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Burner clicks repeatedly but does not ignite
- Burner produces a weak or intermittent spark
- One or more burners fail to light while others work normally
- Ignition system clicks continuously even after burner is lit
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this electrode and harness assembly restores normal ignition immediately.
📦 Part Details
- Part Number: WS01F08076
- Type: Range Electrode & Igniter Harness Assembly — OEM GE Appliances
- Replaces: WS01F07909, 222D9185G020
- Brands: GE
While the harness is disconnected, inspect the igniter switch module and spark module for burn marks or corrosion. A faulty spark module can damage replacement electrodes — confirm the module is outputting correct voltage before reassembly to avoid repeat failures.
⚙️ Installation
Skill Level: Moderate — 30–45 minutes. Disconnect power and shut off the gas supply before servicing. Remove the burner grates and caps to access the electrode tips, then disconnect the harness from the spark module. Route the new harness along the same path, reconnect to the module, and reseat each electrode tip at its burner port. Restore power and gas, then test each burner for consistent ignition before replacing grates.
✓ Compatible Models
Confirmed compatible with JCGBS66SEK1SS, JCGBS66SEK2SS, JGBS66REK1SS and additional GE 30" gas range models. Contact us to verify your model number before ordering.
💡 Pro Tip
Before condemning the harness, remove the burner caps and clean the electrode tips with a dry toothbrush or fine emery cloth. Food debris and moisture are the #1 cause of ignition failures in GE gas ranges — and cleaning costs nothing. If the spark is still weak or absent after cleaning, the electrode assembly is confirmed failed and WS01F08076 is your direct OEM replacement.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
