Oven Not Heating or Showing Error Codes? GE Oven Control Board WS01F10138 – Fix No-Heat & F-Codes Fast
If your GE gas range oven won't heat, displays error codes like F1, F3, or F9, or behaves erratically, a failed oven control board is the most common cause. In most GE gas ranges, the WS01F10138 electronic control board manages all oven functions — temperature regulation, ignition timing, self-clean cycles, and error code processing. When it fails, the oven may refuse to heat entirely, lock the door mid-cycle, or display persistent fault codes that won't clear. ⚡ Common failure point in GE-built gas ranges and slide-in ranges. Part WS01F10138 is the genuine OEM GE replacement that restores full oven control, clears fault codes, and returns accurate temperature regulation.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Range powers on and surface burners ignite normally
- ✔ Oven igniter glows but oven never reaches temperature, OR error codes appear on the display
- ✔ Gas supply to the range is confirmed OK
- ✔ ONLY problem is oven no-heat, erratic temps, error codes, or unresponsive control panel
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Oven won't heat — surface burners work but oven stays cold
- Error codes F1, F3, F9 displayed on control panel
- Oven temperature wildly inaccurate or fluctuates during cooking
- Self-clean cycle won't start or door locks and won't release
- Control panel buttons unresponsive or require multiple presses
- Oven igniter glows but burner never lights
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this control board restores full oven operation immediately.
📦 Part Details
- Part Number: WS01F10138
- Type: Electronic Oven Control Board (Main PCB / Oven Control Module)
- Replaces: 301D1494G004
- Brands: GE
- Condition: Genuine OEM — new in manufacturer packaging
If your oven showed slow ignition or a dim orange glow before the board failed, inspect the oven igniter while the range is open. A failing igniter draws excessive current that accelerates control board wear — replacing both at the same time prevents repeat failures and saves a second service call.
⚙️ Installation
Skill Level: MODERATE — 30–45 minutes, basic electrical comfort required. Disconnect power at the breaker before servicing — this board carries line voltage. Photograph all wiring harness connections before removal, then transfer connectors to the new board one at a time to avoid mis-wiring. This is a static-sensitive component — handle by edges, avoid touching PCB traces. Restore power and run a test bake cycle before full reassembly.
✓ Compatible Models
Confirmed compatible with JCGB735DP1WW, JCGB735EP1ES, JCGB735SP1SS, JCGB745SP1SS, JGB735SP1SS plus additional GE gas range models. Contact us to verify your model number before ordering.
💡 Pro Tip
A healthy GE oven igniter glows bright white and opens the gas valve within 60–90 seconds. If yours glows dim orange or takes longer, it's drawing too much current — this is the #1 cause of premature control board failure. Replace the igniter now and protect your new board investment.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
