Samsung Range DG64-00131A, Replaces DG64 Burner Indicator Light Genuine OEM
When the DG64-00131A burner indicator light fails, the cooktop loses its hot surface warning function — the light that alerts you the glass surface is still dangerously hot after the burner is turned off. This is the genuine OEM replacement indicator light for select Samsung electric ranges. Replacing it restores the full hot surface safety warning and eliminates the burn risk of an unmarked hot cooktop.
Samsung Range DG64-00131A
Is This the Right Part?
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
- Hot surface warning light does not illuminate when burner is on or cooling down
- Indicator light stays on permanently regardless of burner state
- Light flickers or illuminates intermittently
- Indicator light visibly cracked, burned, or physically damaged
- No hot surface warning after burner is turned off — safety hazard
- Control panel shows error code related to surface element or indicator circuit
- OEM Part Number: DG64-00131A
- Manufacturer: Samsung
- Part Type: Burner / Hot Surface Indicator Light
- Function: Illuminates to warn that the glass cooktop surface is still hot after the burner is turned off
- Compatible Brands: Samsung
- Condition: New — Genuine OEM
- Skill Level: Beginner to Intermediate — basic disassembly of control panel required
- Disconnect power to the range before beginning any repair
- Access the indicator light from the control panel or cooktop surface depending on your model
- Disconnect the wiring harness connector and remove the mounting clip or screw
- Install the new indicator light in the same orientation and reconnect the harness
- Restore power and test by activating a burner — light should illuminate and remain on while surface is hot
- Verify your Samsung model number before ordering
If the indicator light is completely dead, check the wiring harness connector at the light assembly for corrosion or a loose terminal before ordering — a poor connection is a common cause of indicator failure and takes 2 minutes to inspect. If the light stays on permanently regardless of burner state, the fault is more likely in the surface element switch or control board sending a constant signal, not the light itself. Confirm the light is the failed component before replacing.
Part Details
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
