Washer Leaking Water? Clamp Assembly 4861ER2001P – Fix Hose Leaks Fast

If your LG washer is leaking water from the drain or inlet hose connection, a failed or loose hose clamp is the most common cause. In most LG front-load washers, the clamp assembly secures the drain hose to the pump or tub outlet, maintaining a watertight seal under pressure. When it fails or loses tension, water escapes at the hose junction — often pooling under the machine or appearing during the spin and drain cycles. ⚡ Common failure point in LG-built front-load washers, especially after repeated high-speed spin cycles. Part 4861ER2001P is the genuine OEM replacement that restores a secure, leak-free hose connection and stops water from escaping the drain system.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your washer powers on and runs cycles normally
• ✔ The drum, motor, and controls all function correctly
• ✔ Your water supply lines and inlet connections are confirmed tight and undamaged
• ✔ The ONLY problem is water leaking from the drain hose connection or hose junction point

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water pooling under or behind the washer during or after a cycle
• Visible moisture or dripping at the drain hose connection point
• Leak occurs primarily during the drain or high-speed spin phase
• Hose appears loose, displaced, or the clamp is visibly cracked or deformed

✔ If these symptoms match, this is the most likely failed component in the drain system.

✔ In most cases, replacing this clamp assembly stops the leak immediately and restores a secure seal.

📦 Part Details

• Part Number: 4861ER2001P
• Type: Hose Clamp Assembly — secures drain or recirculation hose to pump/tub outlet
• Brands: LG

⚙️ Installation

Skill Level: EASY — 15–25 minutes. Disconnect power and water supply before servicing. Pull the washer away from the wall and remove the rear access panel or lower front panel depending on your model. Locate the drain hose clamp at the pump outlet, release the old clamp using pliers, slide the new 4861ER2001P clamp into position, and crimp or tighten to secure. Reconnect hoses, restore power, and run a short cycle to confirm no leaks.

✓ Compatible Models

Confirmed compatible with a wide range of LG front-load washer models including WM2016CW, WM2077CW, WM2277HW, WM2301HR, WM2455HG, WM2487HRM, WM2496HSM, WM2650HRA, WM2688HNM, WM3470HVA, WM3670HWA and additional LG washer models. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages