Dryer Not Heating or Taking Too Long? Blower Wheel DC67-00180B – Fix Airflow Failure Fast
A cracked or clogged dryer blower wheel kills airflow — causing your Samsung dryer to run hot, take multiple cycles to dry a load, or make a loud rumbling noise. In most Samsung DV-series dryers, this is caused by a failed DC67-00180B blower wheel. When it fails, air can't move through the drum efficiently — heat builds up, the thermal fuse trips, drying times double, and the motor strains under the load. ⚡ Common failure point in Samsung-built dryers after 5–10 years of use. Part DC67-00180B is the genuine OEM replacement that restores full airflow, normal drying times, and protects your heating element from burnout.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Dryer powers on and drum spins normally
- ✔ Heating element and thermal fuse test OK
- ✔ Vent duct is clear and unobstructed
- ✔ ONLY problem is poor airflow, long dry times, loud rumbling, or overheating shutoff
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Dryer takes 2–3 cycles to fully dry a normal load
- Dryer runs but produces weak or no heat
- Loud rumbling, thumping, or rattling noise during operation
- Dryer shuts off mid-cycle due to overheating
- Burning smell from lint buildup around a cracked wheel
- Clothes come out damp even after a full cycle
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this blower wheel restores normal drying performance immediately.
📦 Part Details
- Part Number: DC67-00180B
- Type: Genuine OEM Samsung Dryer Blower Wheel / Fan Assembly
- Replaces: DC67-00180BXP — no modification required
- Brands: Samsung
While the drum is out, inspect the thermal fuse and heating element. A failed blower wheel often causes the thermal fuse to blow from heat buildup — if the fuse is open, replace it at the same time to avoid a second service call.
⚙️ Installation
Skill Level: MODERATE — 45–60 minutes. Disconnect power before servicing. Remove the dryer back panel to access the motor and blower assembly. The blower wheel mounts directly to the motor shaft — note the thread direction before removal as some Samsung models use reverse-threaded wheels. Clean all lint from the blower housing before installing the new wheel. Reassemble and run a short test cycle to confirm airflow and heat are restored.
✓ Compatible Models
Compatible with select Samsung DV-series electric and gas dryers. Contact us to verify your model number before ordering.
💡 Pro Tip
A cracked blower wheel almost always means years of lint have packed into the housing. Clean the housing thoroughly before installing the new wheel — skipping this step can cause the new wheel to crack again within months and will restrict airflow even with a new part installed.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
