Samsung Washer Leaking or Not Draining? DC97-18682D Drain Hose Assembly — Fix Water Issues Fast

When your Samsung front-load washer leaks from the bottom or fails to drain completely, a cracked or disconnected drain hose assembly is one of the most common causes. In WF45 and WF50 series washers, the drain hose routes water from the pump to the standpipe or utility sink. When the hose cracks, splits at a connection point, or pulls loose, water escapes onto the floor or the machine fails to drain entirely. ⚡ Common failure point in Samsung front-load washers after 3–5 years of use. Part DC97-18682D is the genuine OEM replacement drain hose assembly that restores a watertight drain path and full drainage in under 30 minutes.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and runs cycles normally
• ✔ Pump motor runs — you can hear it during drain phase
• ✔ Standpipe or drain connection at the wall is clear and not clogged
• ✔ Drain filter (front access panel) has been cleaned and is not blocked
• ✔ ONLY problem is water on the floor, slow drain, or standing water in the drum

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water pooling under or in front of the washer — most common complaint
• Washer not draining — standing water left in drum after cycle
• Visible crack, split, or kink in the drain hose
• Hose pulled loose from pump outlet or standpipe connection
• 5E or ND error code displayed (drain fault)
• Musty smell from water trapped in a kinked or low-hanging hose

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing the drain hose assembly resolves leaking and drainage issues immediately.

📦 Part Details

• Part Number: DC97-18682D
• Type: Drain hose assembly — pump outlet to standpipe, Samsung OEM
• Replaces: OEM direct-fit drain hose assembly (no modification required)
• Brands: Samsung

⚙️ Installation

Skill Level: EASY — 20–30 minutes. Disconnect power and turn off the water supply before beginning. The drain hose is accessed from the rear of the machine — pull the washer away from the wall, loosen the hose clamp at the pump outlet, and slide the hose free. Route the new hose in the same path, secure the clamp, and reconnect to the standpipe. Have towels ready for residual water. No special tools required.

💡 Pro Tip

Model hub pages: Samsung Washer Parts Canada

✓ Model-Specific Repair Pages