Genuine OEM Replacement Part
Samsung Range Oven Door Liner DG94-00063A – Genuine OEM
Part# DG94-00063A
Oven Door Inner Liner
Fits Samsung
Range · Oven
Samsung Oven Door Cracked or Heat Escaping? Door Liner DG94-00063A – Restore Door Integrity Fast
If your Samsung range oven door inner liner is cracked, warped, or damaged, heat escapes the oven cavity, cooking performance drops, and the outer door glass can overheat to unsafe levels. In most Samsung ranges, the oven door liner forms the inner structural panel of the door assembly — it retains heat, protects the door glass from direct oven temperatures, and provides the mounting surface for the door seal. ⚡ Common damage point on Samsung ranges with heavy use or thermal shock. Part DG94-00063A is the genuine OEM replacement door liner that restores full thermal containment and door structural integrity.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Range powers on and oven heating elements function normally
- ✔ Oven temperature sensor and control board are confirmed working
- ✔ Door hinges and outer door glass are intact and undamaged
- ✔ Part number DG94-00063A matches your model’s parts diagram
- ✔ ONLY problem is a cracked, warped, or damaged inner door liner panel
Not sure? Send us your model number — we’ll confirm before you order.
🔧 Common Symptoms
- Inner door liner visibly cracked or broken — most common after thermal shock or impact
- Heat escaping from the oven door during operation — oven takes longer to reach temperature
- Outer door glass excessively hot to the touch during normal baking
- Door seal no longer sits flush — liner warped or mounting surface damaged
- Visible discolouration, bubbling, or delamination on the inner door panel
- Rattling or loose panel inside the door assembly when opening or closing
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this door liner restores full heat retention and door integrity immediately.
📦 Part Details
-
Part Number: DG94-00063A
-
Type: Range Oven Door Inner Liner Panel
-
Fit: OEM direct-fit replacement (no modification required)
-
Brands: Samsung
⚠️ Recommended While Repairing:
While the door is disassembled, inspect the door seal (gasket) for hardening, cracking, or compression loss — a damaged seal allows heat to escape even with a new liner installed. Replace the door seal at the same time to ensure a complete repair.
⚙️ Installation
Skill Level: Moderate — 30–45 minutes. Disconnect power before beginning. Remove the oven door by lifting it off the hinge arms, then disassemble the door by removing the outer glass panel screws to access the inner liner. Remove the damaged liner, transfer any retained hardware or seal clips to the new liner, reassemble the door in reverse order, and rehang on the hinge arms. Restore power and run the oven to confirm heat retention before returning to service.
✓ Compatible Models
Confirmed compatible with Samsung range and oven models using the DG94-00063A door liner. Contact us to verify your model number before ordering.
💡 Pro Tip
Photograph the Door Assembly Before Disassembly:
Samsung oven doors have multiple layers of glass, insulation, and trim that must be reassembled in the correct order — a single misplaced layer causes heat loss and glass cracking. Take photos of each layer as you remove it so reassembly is straightforward. This is especially important if the door has been previously repaired or modified.
