Oven Not Heating or Baking Unevenly? Bake Element W11182108 – Fix No-Heat Oven Fast
When a Whirlpool electric range oven stops heating or bakes unevenly, the lower bake element is the most common cause. In most Whirlpool-built electric ranges, this is caused by a failed bake element. When it fails, the oven won’t reach temperature, food bakes unevenly or not at all, and the element may show visible burn marks or breaks. ⚡ Common failure point in WFE, WFC, ACR, and AER series Whirlpool-built electric ranges. Part W11182108 is the genuine OEM replacement that restores full oven heating immediately — direct plug-in swap, replaces W11022836 and W11111743 with no modification required.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Range is a Whirlpool-built electric model (Whirlpool, Amana, Maytag, Amana, or Inglis)
- ✔ Broil element confirmed working — only baking is affected
- ✔ Oven temperature sensor tested and confirmed within spec
- ✔ No tripped breaker or blown fuse at the panel
- ✔ ONLY problem is oven not heating, slow to heat, or uneven baking results
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Oven not heating at all — burners work but oven is cold
- Oven takes much longer than normal to preheat
- Food undercooked on the bottom or baking unevenly
- Visible burn mark, crack, or blister on the bake element
- Element glows red in one spot only, or not at all
- F1, F3, or heating error codes displayed on the control panel
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this bake element restores normal oven operation immediately.
📦 Part Details
- Part Number: W11182108
- Type: Lower Oven Bake Element — 2300W, 240V, nichrome wire in steel sheath with mounting brackets and factory terminals
- Replaces: W11022836, W11111743 — no modification required
- Brands: Whirlpool, Amana, Maytag, Inglis
⚙️ Installation Notes
Skill Level: EASY — 15–20 minutes. Disconnect power at the breaker before servicing — this element carries 240V. Open the oven door, remove the two mounting screws at the back of the oven floor, pull the element forward to expose the terminals, disconnect the wires, and connect them to the new element. Slide back into position, reinstall screws, restore power, and run a bake cycle to confirm. No tools beyond a screwdriver required.
💡 Pro Tip
A failed oven temperature sensor (RTD probe) produces identical symptoms — oven won’t heat or heats erratically — and costs a fraction of the element. Before ordering, test the sensor resistance with a multimeter (should read ~1080Ω at room temperature). If the sensor checks out and the element shows visible damage or an open circuit, W11182108 is your fix.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
