Microwave Dead or Unresponsive? Control Board W11325784 – Fix No-Power Fast
A microwave that won't start, has a blank display, or has completely unresponsive controls is almost always a failed electronic control board. In Whirlpool-platform microwaves, the control board is the central processing unit that manages all functions — when it fails, the microwave may appear completely dead, display error codes, or respond erratically to button presses. ⚡ Common failure point in Whirlpool, Maytag, and KitchenAid over-the-range and countertop microwaves. Part W11325784 is the genuine OEM replacement control board that restores full microwave functionality and directly supersedes W11289988 — no modification required.
Model-specific repair guides: Whirlpool Microwave Parts, Maytag Microwave Parts, KitchenAid Microwave Parts
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your microwave has power at the outlet (confirmed with another device)
- ✔ The door switches and door latch have been tested and are not the cause
- ✔ The thermal fuse has been tested and confirmed not blown
- ✔ The main fuse is intact and not the source of the no-power condition
- ✔ ONLY problem is the control panel not responding, display blank, or microwave completely dead despite power confirmed at outlet
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Microwave completely dead — no display, no response to any button — most common complaint
- Control panel buttons unresponsive or only some buttons work
- Display shows error code (F1, F2, F3, or similar) and won't clear
- Microwave starts on its own or runs without being activated
- Microwave stops mid-cycle and won't restart
- Clock resets constantly or display flickers
✔ If these symptoms match, the control board is the most likely failed component in the system.
✔ In most cases, replacing the control board with W11325784 restores full microwave operation immediately.
📦 Part Details
- Part Number: W11325784
- Type: Genuine OEM Whirlpool Microwave Electronic Control Board Assembly
- Replaces: OEM direct-fit control board — supersedes W11289988 (no modification required)
- Brands: Whirlpool, Maytag, KitchenAid
While the control panel is disassembled, inspect the door switches (typically 3 on Whirlpool-platform microwaves) — a failed door switch is the #1 cause of control board burnout and will destroy a new board if not replaced. Door switches are inexpensive and should be tested or replaced as a set whenever the control board is changed.
⚙️ Installation
Skill Level: MODERATE — Allow 30–60 minutes. Unplug the microwave before beginning any work — capacitors inside retain lethal charge even after unplugging; discharge the capacitor before touching internal components. For over-the-range models, remove the unit from the wall mount to access the control board behind the front panel. Disconnect the ribbon cable and wire harness connectors, swap the board, and reassemble in reverse. Ensure all connectors are fully seated before restoring power.
💡 Pro Tip
Microwave capacitors store up to 2,100V and remain charged for hours after unplugging — this is a lethal hazard. Before touching any internal component, discharge the capacitor using a well-insulated screwdriver across the terminals. Never skip this step, even for a quick inspection. If you're not comfortable with high-voltage discharge procedures, this repair is best left to a licensed technician.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
