Washer Not Draining or Leaking? Drain Hose W11803769 – Fix It Fast
A cracked, kinked, or failed drain hose is one of the most common causes of washer leaks and no-drain errors. In most Whirlpool and Maytag front-load and top-load washers, the drain hose routes water from the pump to your standpipe or utility sink. When it fails, water pools under the machine, triggers error codes, or simply won't evacuate the drum. ⚡ Common failure point in Whirlpool-platform washers. Part W11803769 is the genuine OEM replacement that restores a sealed, leak-free drain path and clears drain-related error codes immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer powers on and the drum spins normally
- ✔ The pump motor runs (you can hear it attempt to drain)
- ✔ No blockage found in the pump filter or standpipe
- ✔ ONLY problem is water leaking from the hose or washer not fully draining
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Water leaking from the back or bottom of the washer
- F9 E1, F21, or "Drain" error codes on the display
- Washer stops mid-cycle with standing water in the drum
- Visible cracks, kinks, or brittleness in the existing drain hose
✔ If these symptoms match, the drain hose is the most likely failed component in the system.
✔ In most cases, replacing this drain hose restores normal operation immediately.
📦 Part Details
- Part Number: W11803769
- Type: Washer Drain Hose — OEM Genuine Replacement
- Replaces: W11803769 (verify cross-references with your model number)
- Brands: Whirlpool, Maytag, Amana, Roper
Inspect the pump filter and drain pump housing while the hose is disconnected — debris buildup is often a co-contributor to drain failures and takes 2 minutes to clear while you're already in there.
⚙️ Installation
Skill Level: EASY — 15–30 minutes. Disconnect power and water supply before servicing. Pull the washer away from the wall, locate the drain hose at the rear pump outlet, release the clamp, swap the hose, and re-secure. No special tools required beyond a flathead screwdriver or pliers.
✓ Compatible Models
Confirmed compatible with select Whirlpool, Maytag, Amana, and Roper washer models. Contact us to verify your model number before ordering.
💡 Pro Tip
The original hose clamp often loses tension after years of heat cycling. Pick up a new stainless worm-drive clamp when replacing the hose — it's a $2 fix that prevents a callback leak and saves a second service call.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
