GE Washer Won't Start? Power Button Support WG04A04572 — Fix Unresponsive Start Button Fast
If your GE washer's start or power button feels loose, won't click, or fails to register a press, the power button support bracket is the most common cause. In most GE top-load and front-load washers, the button support is a small plastic bracket that holds the start/power button in proper alignment against the control board actuator. When it cracks, warps, or breaks free, the button no longer makes consistent contact — leaving the washer unresponsive to start commands even though the machine has power. ⚡ Common failure point in GE-built washers and Hotpoint-branded units sharing the same platform. Part WG04A04572 is the genuine OEM replacement that restores proper button alignment and reliable start function — no soldering, no control board replacement required.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Washer powers on — display or indicator lights are active
- ✔ All other cycles and settings respond normally
- ✔ Door latch is confirmed closed and locked
- ✔ ONLY problem is the start/power button not registering or feeling loose/broken
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Start or power button feels loose, wobbly, or has no resistance when pressed
- Button press does not register — washer does not begin cycle
- Button appears physically broken or has fallen inward behind the panel
- Washer was working normally until button was pressed firmly and snapped
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this power button support restores normal start function immediately.
📦 Part Details
- Part Number: WG04A04572
- Type: Power Button Support Bracket — OEM plastic actuator support for washer control panel start/power button
- Brands: GE, Hotpoint
While the control panel is open, inspect the start button actuator cap and the control panel overlay for cracks or delamination. If the button cap itself is cracked or missing, it should be replaced at the same time — doing both in one service call saves labour and prevents a repeat repair within weeks.
⚙️ Installation
Skill Level: EASY — 15 to 30 minutes. Disconnect power before servicing. Remove the washer's control panel screws (typically located at the rear or underside of the panel), carefully lift or slide the panel free, and locate the broken button support bracket behind the start button. Snap or clip the new WG04A04572 support into position, verify the button actuates smoothly, then reassemble the panel and restore power to test.
✓ Compatible Models
Confirmed compatible with select GE and Hotpoint top-load washer models. Contact us to verify your model number before ordering.
💡 Pro Tip
A broken button support is frequently misdiagnosed as a failed control board — a repair that costs 5–10× more. Before ordering a board, always physically inspect the button support bracket. If the button has no resistance or has visibly shifted position, this $12 bracket is almost always the fix. Save the board replacement for after you've confirmed the support is intact and the button still won't register.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
