Oven Not Heating Evenly? Bake Burner WS01F09975 – Fix Oven Baking Failure Fast

If your GE Monogram or Café range oven won't heat, bakes unevenly, or the bottom element fails to glow, the oven bake burner is the most common cause. In most GE-built gas ranges, the bake burner degrades over time and can no longer sustain the consistent flame needed for even oven temperatures. When it fails, food bakes unevenly, the oven takes too long to preheat, or the oven won't heat at all. ⚡ Common failure point in GE Monogram ZGP and CGY366 series ranges. Part WS01F09975 is the genuine OEM replacement that restores consistent oven heat with a direct drop-in fit and no modifications required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your range powers on and surface burners work normally
• ✔ The oven ignitor glows but the burner doesn't light, or lights weakly
• ✔ Gas supply to the range is confirmed on
• ✔ The oven ignitor has been tested and is functioning correctly
• ✔ ONLY problem is the oven not heating, heating unevenly, or failing to reach set temperature

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Oven won't heat or takes excessively long to preheat
• Uneven baking — food burns on one side or is raw in the centre
• Oven ignitor glows but burner never lights
• Oven shuts off mid-cycle or fails to maintain temperature
• Visible damage, cracks, or corrosion on the bake burner element
• Oven works intermittently — heats sometimes but not consistently

✔ If these symptoms match, the bake burner is the most likely failed component in the system.

✔ In most cases, replacing the bake burner restores normal oven operation immediately.

📦 Part Details

• Part Number: WS01F09975
• Type: OEM Oven Bake Burner Assembly — genuine GE factory part
• Replaces: WB28K10669 (no modification required)
• Brands: GE Monogram, Café, GE

⚙️ Installation Notes

Skill Level: MODERATE — 30–45 minutes. Shut off the gas supply and unplug the range before beginning. Remove the oven racks and bottom oven panel to access the bake burner. Disconnect the burner from the gas orifice and remove the mounting screws. Install the new WS01F09975, reconnect the gas orifice fitting, and secure the mounting hardware. Reinstall the oven panel and racks, restore gas and power, then run a preheat cycle to confirm even heating. Do not overtighten the orifice fitting — hand-tight plus a quarter turn is sufficient to prevent gas leaks.

💡 Pro Tip

🔗 Model Repair Hubs

Find part lists, diagrams, and repair guides for your specific range model: ZGP304NR1SS, ZGP304NR2SS, ZGP364NDN1SS, ZGP364NDR1SS, ZGP364NDR2SS, ZGP364NDR3SS, ZGP364NDR5SS, ZGP364NRR1SS, ZGP364NRR2SS, ZGP364NRR3SS, ZGP366NDN1SS, ZGP366NN1SS, ZGP366NR1SS, ZGP366NR2SS, CGY366P2M1S1, CGY366P3M1D1, CGY366P4M1W2, CGY366SEL1SS

✓ Model-Specific Repair Pages