GE Café Range Burners Not Igniting or Oven Not Heating? Harness Burner Box WS01F10257 – Fix Ignition & Wiring Faults Fast

A damaged or failed oven harness burner box is a common cause of intermittent burner ignition failures, oven not heating, and electrical faults in GE Café 36-inch gas and dual-fuel ranges. In most GE Café ranges, the harness burner box is the wiring assembly that connects the burner box to the oven control system — when it fails due to heat damage, connector corrosion, or wiring fatigue, the control system loses communication with the burners and ignition becomes intermittent or stops entirely. ⚡ Common failure point in GE Café 36-inch ranges subject to high heat and continuous ignition cycling. Part WS01F10257 is the genuine OEM replacement harness burner box that restores full burner ignition and oven electrical communication with no modifications required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your range has confirmed power and the control panel responds normally
• ✔ The spark module and igniter electrodes have been inspected and are not the source of the ignition fault
• ✔ The gas supply valve is open and gas pressure has been confirmed at the range
• ✔ The wiring harness shows visible damage, melting, corrosion, or the connectors will not seat securely
• ✔ ONLY problem is intermittent or failed burner ignition, oven not heating, or electrical fault near the burner box area

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Burners not igniting or clicking but not lighting — most common harness failure symptom
• Intermittent ignition — burners light sometimes but fail randomly
• Oven not heating despite controls responding and set temperature displayed
• Burning smell or visible melting near the burner box wiring area
• Wiring harness connectors visibly corroded, cracked, or will not seat securely
• Electrical fault or breaker trip when range is in use

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this harness burner box restores full burner ignition and oven operation immediately.

📦 Part Details

• Part Number: WS01F10257
• Type: Oven Harness Burner Box – wiring assembly connecting the burner box to the oven control system, routing ignition signals and power to the surface burners and oven cavity
• Replaces: OEM direct-fit harness burner box — supersedes 307D1359G010 (no modification required)
• Brands: GE, GE Café

⚙️ Installation

Skill Level: ADVANCED — 45–75 minutes. Disconnect power at the breaker and confirm the gas supply is off before beginning any disassembly. Photograph all harness connector positions and routing paths before disconnecting — the burner box harness has multiple connectors that must be reinstalled in the correct positions. Access the harness by removing the cooktop or rear panel depending on your model, swap in the new WS01F10257 harness, reconnect all terminals firmly, restore power and gas, then test all burners and oven functions before reassembling panels.

✓ Compatible Models

Part WS01F10257 supersedes 307D1359G010 and is confirmed compatible with C2Y366P2T1S1, C2Y366P3T1D1, C2Y366P4T1W2, CGY366P2T1S1, CGY366P3T1D1, CGY366P4T1W2 (GE Café 36-inch gas and dual-fuel ranges). Contact us with your model number to confirm compatibility before ordering.

💡 Pro Tip